Lora6102AES-1W AES Encrypted LORA High Power Wireless Transceiver Data Transmission Module
LoRa6102AES is an industrial wireless transceiver data transmission module with aluminum housing ,based on SX1276/1278 chips from Semtech. This module adopts LORA technology to achieve high effective sensitivity and superior anti-interference. The communication distance and receiver sensitivity are far exceeds the FSK, GFSK modulation. With superior anti-interference. Lora6102AES has 1W output power and TTL/RS232/RS485 interface available. It is widely applied in meter reading, remote industrial control, etc
Transmission distance in open area up to 8000 meters @ 91bps
433/470 (1W) MHz 868/915 (500Mw) MHz
Sensitivity: -139 dBm
Max output power: 1W/500mW（+30dBm/+27dBm）
Working voltage: 3.3 ~ 6.5 V
Working temperature: -40 ~ +85 °C
Remote control telemetry
Remote meter reading
Industrial data acquisition
Wireless data communication
1) Power on Reset
Standard supply voltage of 5V (ordinary lithium battery of 4.2V is also applicable)，After powered on reset, the TX LED (Red) and RX LED (Blue) will blink 3 times,（If no lights, module may damaged）,The total reset time is around 2s, as below
Note：Contact us to customize if you want to shorten the POR time.
2) Working Mode
The CS and SET Pin is internally pulled up. Pull CS pin high or leave it open will make Lora6102AES enter into working mode.
In working mode, Lora6102AES stay in receiving mode and wait for the series signal and RF signal. Lora6102AES can connect with any device which is standard TTL interface.
When series signal comes, Lora6102AES will check the input series signal if there is any error, and then transmit the received data out via RF automatically if no errors found.
When RF signal comes, Lora6102AES will check the input RF signals if there is any error, and then transmit the received data out via series port automatically if no errors found.
When one packet is transmitted successfully, the Red LED will blink once.
When one packet is received and verified with no problem, the Blue LED will blink once.
The easiest way to test the module is using computer(PC software)
Mechanical dimension (mm):
Encrypted LORA High Power Wireless Transceiver Data Transmission Module